STM32MP157C-DK2 소개

https://make.e4ds.com/ 에서 STM32MP1 완전 정복 퀘스트 챌린지를 진행한다.

 

임베디드 보드에 리눅스를 올려서 사용하는것은 처음이라 퀘스트를 수행하면서 블로그에 기록을 남기려한다.

 

퀘스트를 진행하는데 사용되는 STM32MP157C-DK1 보드에 대해 소개하자면

STM32MP157C-DK2  보드

 

• Common features
  • STM32MP157 Arm®-based dual Cortex®-A7 32 bits + Cortex®-M4 32 bits MPU in TFBGA361 package
  • ST PMIC STPMIC1
  • 4-Gbit DDR3L, 16 bits, 533 MHz
  • 1-Gbps Ethernet (RGMII) compliant with IEEE-802.3ab
  • USB OTG HS
  • Audio codec
  • 4 user LEDs
  • 2 user and reset push-buttons, 1 wake-up button
  • 5 V / 3 A USB Type-CTM power supply input (not provided)
  • Board connectors:Ethernet RJ454 × USB Host Type-AUSB Type-CTM DRPMIPI DSISMHDMI®Stereo headset jack including analog microphone inputmicroSDTM cardGPIO expansion connector (Raspberry Pi® shields capability)ARDUINO® Uno V3 expansion connectors
  • On-board ST-LINK/V2-1 debugger/programmer with USB re-enumeration capability: Virtual COM port and debug port
  • STM32CubeMP1 and full mainline open-source Linux® STM32 MPU OpenSTLinux Distribution (such as STM32MP1Starter) software and examples
  • Support of a wide choice of Integrated Development Environments (IDEs) including IARTM, Keil®, GCC-based IDEs
• Board-specific features
  • 4" TFT 480×800 pixels with LED backlight, MIPI DSISM interface, and capacitive touch panel
  • Wi-Fi® 802.11b/g/n
  • Bluetooth® Low Energy 4.1

 

 

스펙만 봐도 어마어마한 녀석인거 같다. 

이것으로 무엇을 할 수 있을지는 퀘스트를 진행하면서 알아가 보도록 하자.